How Can We Help?

Print

Wire connections to the ACE: Pluggable terminal connectors

 

ACE units come with pluggable terminal connectors

Looking at the first connector, from top to bottom:

  • 1 position for V0 (Ground / GND)
  • 6 positions for the signals from 1 to 6
  • 1 position not connected or for +VCC

To insert fine solid electrical wire

We suggest using AWG 24 / 0.205 mm2 solid wire. You can insert up to 2 solid wires of this type per connector hole.

  • Strip the wire insulation back about 5 mm +/- 1
  • Insert each wire into the proper round connector hole and push the wire in.
    • It should push in very easily and lock in place.
    • You should not be able to pull the wire back out.

Solide AWG 24 / 0.205 mm2 wire from telephone cable 4*2 AGW24 (0.2 mm2) Here, with 2 wires by hole

Solid AWG 24 / 0.205 mm2 wire from Ethernet cable

Flat screwdriver 2 mm

To insert fine multistranded flexible electrical wire

For multi-stranded flexible wires, we suggest AWG 24 / 0.205 mm2 with E0208 (not E0206) crimp ferrules With crimp ferrules, you can insert each wire without tool like the solid wire. Without crimp ferrules:

  • Insert the blade of a connector tool (screwdriver) in the rectangular hole directly below the connection hole.
    • This will open the spring capture connection.
  • Simply push your wire in, then remove the blade.
  • If you pull the wire, it should be captured in place and will not come out.

Stranded AWG 24 / 0.205 mm2 wire with E0208 crimp ferrules

Stranded AWG 24 / 0.205 mm2 wire from Ethernet patch cable

To remove any wire electric from the connector

  • Use the connector tool.
  • Push the blade into the rectangular hole below the wire to open the spring clamp
  • Pull the wire out the hole
  • Remove the connector tool.